[Location: Location_Category='CONTINENT', Location_Type='ANTARCTICA', Detailed_Location='CAPE ROBERTS']
Cape Roberts Tide Gauge records since 1990Entry ID: K042_1990_2012_NZ_1
Abstract: A tide gauge was installed at Cape Roberts in November 1990 and has been in near continuous operation since. A 10 minute average of water depth was recorded each hour with hourly averages of wind speed and direction, air temperature and solar radiation. From 2000 the recording frequency was increased from every hour to every 10 minutes. From 2003 data is read every 10 seconds and an average value ... (from 60 readings) is calculated every 5 minutes and recorded. Barometric pressure was measured as well, starting in 2003, with six barometric pressure readings made between 2 and 3 minutes in the 5-minute interval and averaged and recorded with the tide value. Each year the rise and fall of the sea ice is observed over a 2 - 3 day period during a spring tide using GPS. These measurements are related to a tide gauge bench mark and the sea surface to enable the reliability of the tide gauge to be checked. The tide gauge data is archived by Land Information New Zealand. The operation of the tide gauge has encouraged USGS and Ohio State University workers to establish Cape Roberts as a primary datum for their GPS stress and deformation control network in South Victoria Land. In 2000 LINZ in partnership with USGS have established a continuously recording GPS station at Cape Roberts that will also require continued tidal records.
Each season a geodetic grade GPS receiver is set up on the sea ice near the tide gauge and another is set up on a permanent reference mark ashore. The GPS “observes” the rise and fall of the tide by measuring the changing height of the sea ice. A hole is drilled through the sea ice to enable the height of the reference point of the GPS receiver above the sea surface to be determined. The relationship of the height of the shore-based reference mark and the zero of the sea level sensor is known. These connections enable the height of the sea surface as determined by the sea level sensor to be compared to the height as determined by the GPS measurements.
Start Date: 1990-01-01
Temporal Resolution: 10 seconds & claculated every 5 minutes
ISO Topic Category
Quality The tide gauge data is archived by Land Information New Zealand.
Data for Cape Roberts since 8 November 2007 is available from the LINZ web-site (http://apps.linz.govt.nz/ftp/sea_level_data/ROBT/). Data prior to then: contact Glen Rowe, or (preferably) by sending an enquiry to firstname.lastname@example.org
Data Set Progress
Phone: +64 4 463 5396
Fax: +64 4 463 5186
Email: alex.pyne at vuw.ac.nz
Antarctic Research Centre Victoria University of Wellington PO BOX 600
Postal Code: 6140
Country: New Zealand
Role: TECHNICAL CONTACT
Phone: +64 4 460 0569
Fax: +64 4 498 3837
Email: growe at linz.govt.nz
Land Information New Zealand PO Box 5501
Country: New Zealand
Goring, D.G. And Pyne, A.R. 2003. Observations of sea level variability in the Ross Sea, Antarctica. New Zealand Journal of Marine and Freshwater Research 37: 241-249.
Han, A.S.K. 2002. An investigation into the tidal regime at Cape Roberts in the Ross Sea, Antarctica. BSc (Hons), University of Otage, Dunedin, New Zealand.
Extended Metadata Properties
(Click to view more)
Creation and Review Dates
DIF Creation Date: 2004-06-01
Last DIF Revision Date: 2012-06-15