Structure and geochemistry of Macquarie Island oceanic crustEntry ID: ASAC_903
Abstract: Owing to the fact that the principal investigator died before data were able to be archived, the only available data are in the form of the referenced paper, which is available as a PDF download to AAD staff only.
From the referenced papers:
Macquarie Island is an exposure above sea level of the Macquarie Ridge Complex, on the boundary between the Australian and Pacific plates south of New ... Zealand. Geodynamic reconstructions show that at ca. 12-9.5 Ma, oceanic crust of the Macquarie Island region was created at this plate boundary within a system of short spreading-ridge segments linked by large-offset transform faults. At this time, the spreading rate was slowing (less than 10 mm/yr half-spreading rate) and magmatism was waning. Probably before 5 Ma, and possibly before the extinct spreading ridge had subsided, the plate boundary became obliquely convergent, and crustal blocks were rotated, tilted, and uplifted along the ridge to form the island. Planation by marine erosion has exposed sections through the oceanic crust.
The magmatism that built the oceanic crust produced melts similar in composition to the widespread normal to enriched mid-oceanic ridge basalt (N- to E-MORB) suite found in many spreading ridges, but the melts ranged beyond E-MORB to primitive, highly enriched, and silica-undersaturated compositions. These compositions form one end member of a continuum from MORB but seem not to have been derived from a MORB-source mantle, despite sharing a Pacific MORB isotopic signature. The survival of these primitive melts may be due to their origin in a slow-spreading system that must have been closing down as extension along the plate boundary gave way to transpression, putting a stop to the upwelling of asthenosphere and decompression melting. In a more energetic, faster-spreading system, mixing would have been more efficient, the presence of this end member could not easily have been inferred from its isotopic composition, and the igneous rocks would have resembled a typical N- to E-MORB suite. Macquarie Island may therefore provide a type example of magmatism at a very slow spreading ridge and a clue to the origins of E-MORB.
Macquarie Island is an exposure above sea-level of part of the crest of the Macquarie Ridge. The ridge marks the Australia-Pacific plate boundary south of New Zealand, where the plate boundary has evolved progressively since Eocene times from an oceanic spreading system into a system of long transform faults linked by short spreading segments, and currently into a right-lateral strike-slip plate boundary. The rocks of Macquarie Island were formed during spreading at this plate boundary in Miocene times, and include intrusive rocks (mantle and cumulate periodites, gabbros, sheeted dolerite dyke complexes), volcanic rocks (N- to E-MORB pillow lavas, picrites, breccias, hyaloclastites), and associated sediments. A set of Macquarie Island basaltic glasses has been analysed by electron microphobe for major elements, S, Cl, and F; by Fourier transform infrared spectroscopy for H2O; by laser ablation-inductively coupled plasma mass spectrometry for trace elements; and by secondary ion mass spectrometry for Sr, Nd and Pb isotopes. Macquarie Island basaltic glasses are divided into two compositional groups according to their mg-number-K2O relationships. Near-primitive basaltic glasses (Group I) have the highest mg-number (63-69), and high Al2O3 and CaO contents at a given K2O content, and carry microphenocrysts of primitive olivine (Fo86-89.5). Their bulk compositions are used to calculate primary melt compositions in equilibrium with the most magnesian Macquarie Island olivines (Fo90.5). Fractionated, Group II, basaltic glasses are saturated with olivine + plagioclase + or - clinopyroxene, and have lower mg-number (57-67), and relatively low Al2O3 and CaO contents. Group I glasses define a seriate variation within the compositional spectrum of MORB, and extend the compositional range from N-MORB compositions to enriched compositions that represent a new primitive enriched MORB end-member. Compared with N-MORB, this new end-member is characterised by relatively low contents of MgO, FeO, SiO2 and CaO, coupled with high contents of Al2O3, TiO2, NaO2, P2O5, K2O and incompatible trace elements, and has the most radiogenic Sr and Pb regional isotope composition. These unusual melt compositions could have been generated by low-degree partial melting of an enriched mantle peridotite source, and were erupted without significant mixing with common -MORB magmas. The mantle in the Macquarie Island region must have been enriched and heterogenous on a very fine scale. We uggest that the mantle enrichment implicated in this study is more likely to be a regional signature that is shared by the Balleny Islands magmatism than directly related to the hypothetical Balleny plume itself.
Data Set Citation
Dataset Originator/Creator: Varne, R. and Davidson, G.
Dataset Title: Structure and geochemistry of Macquarie Island oceanic crust
Dataset Series Name: CAASM Metadata
Dataset Publisher: Australian Antarctic Data CentreOnline Resource: https://data.aad.gov.au/aadc/metadata/metadata_redirect.cfm?md=/AMD...
Start Date: 1995-09-30Stop Date: 1996-03-31
SOLID EARTH > ROCKS/MINERALS/CRYSTALS > ELEMENTS > MAJOR ELEMENTS
SOLID EARTH > ROCKS/MINERALS/CRYSTALS > ELEMENTS > MINOR ELEMENTS
SOLID EARTH > ROCKS/MINERALS/CRYSTALS > ELEMENTS > TRACE ELEMENTS
SOLID EARTH > GEOCHEMISTRY
SOLID EARTH > GRAVITY/GRAVITATIONAL FIELD > CRUSTAL MOTION > OCEAN CRUST DEFORMATION
SOLID EARTH > TECTONICS
SOLID EARTH > TECTONICS > PLATE TECTONICS
Quality Values provided in temporal coverage are approximate only.
Access Constraints A PDF copy of the referenced papers are available for download from the provided URL to AAD staff only.
Use Constraints This data set conforms to the PICCCBY Attribution License
Please follow instructions listed in the citation reference provided at http://data.aad.gov.au/aadc/metadata/citation.cfm?entry_id=ASAC_904 when using these data.
Data Set Progress
Distribution Media: HTTP
Distribution Size: 9562 kb
Distribution Format: PDF
Role: TECHNICAL CONTACT
Role: DIF AUTHOR
Role: TECHNICAL CONTACT
Phone: +61 3 6226 2815
Fax: +61 3 6223 2547
Email: Garry.Davidson at utas.edu.au
DEPARTMENT OF GEOLOGY GPO BOX 252-79 University of Tasmania
Province or State: Tasmania
Postal Code: 7001
Varne R., Brown A.V., Falloon T. (2000), Macquarie Island: its geology and structural history, and the timing and tectonic setting of its N-MORB to E-MORB magmatism., Geological Society of America, Special Publication. Ophiolites and oceanic crust: new insights from field studies and the Ocean Drilling Program.
Kamenetsky V.S., Everard J.L., Crawford A.J., Varne R., Eggins S.M., Lanyon R. (2000), Enriched end-member of primitive MORB melts: petrology and geochemistry of glasses from Macquarie Island (SW Pacific), Journal of Petrology
Kamenetsky V., Crawford A.J., Varne R., Lanyon R. (1996), Primitive glasses from the Macquarie Island (SW Pacific ophiolite): an extended range of MORB parental compositions and implications for mantle melting, 13th Australian Geological Convention, Abstracts
Extended Metadata Properties
(Click to view more)
Creation and Review Dates
DIF Creation Date: 2000-08-08
Last DIF Revision Date: 2017-08-24